Without any lag
---
Hatch Patterns are included in the dxf.
Property 'From Entity' = True and usually at the bottom in the pattern list.
These supersede the installed ones.
Without the .pat file installed Qcad can not revert to it.
There should be a file HPZG60N1.pat (or hpzg60n1.pat) in
../Qcad/Patterns/ under imperial and/or under metric.
One needs both while swapping between drawings with different units.
Qcad keeps the old measurement system while converting to another unit.
Patterns are loaded only once at boot.
After you save it under Win, make sure the file is there. The UAC may intervene.
A most simple pattern.
Good numbers maxed out in digits would be:
0.577350269189626
1.15470053837925
What gives: (and fit 80 chars)
Code: Select all
60,0,0,0.577350269189626,-1,1.15470053837925,-1.15470053837925
120,0,0,0.577350269189626,1,1.15470053837925,-1.15470053837925
Properly addressing the 1e right hand clone with dX & dY gives:
Code: Select all
60,0,0,1.73205080756888,1,1.15470053837925,-1.15470053837925
120,0,0,0.577350269189626,1,1.15470053837925,-1.15470053837925
It doesn't care what variant of the above. As long as the pat file exist.
Remark, I am hatching at 0 degree and rather near the origin.
Regards,
CVH