I love QCAD, but...I have to be very careful in snapping to a point i.e. end point of a line, center of circle etc. If I am not careful to hold the mouse motionless for just a bit, the position will drag off of the snap point.
I have seen this behavior on many different drawings. I do not think the drawing I have attached is unique or can add anything to the discussion, but I had used a ordinate dimension to print this out for a guy who could not read a dxf. bottom line is I had to go back and review the center property of each circle to verify the coordinate. I found 2 errors that have been fixed on the attached file where it did not look like the dimension line did not point exactly at the center.
I am using a conventional mouse, and have seen this behavior on multiple computers.
Is there anything I can do about this other than be really careful?
coordinate pick
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
coordinate pick
- Attachments
-
- insulator4 dimensioned.DXF
- (218.74 KiB) Downloaded 404 times
Re: coordinate pick
You could try to find a for you better working setting within the Cursor Range.
Work smart, not hard: QCad Pro
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."