Post Processors - Centroid

Discussions around the CAM Add-On of QCAD.

Moderator: andrew

Forum rules

Always indicate your operating system and QCAD version.

Indicate the post processor used.

Attach drawing files and screenshots.

Post one question per topic.

Post Reply
scarab4t
Registered Member
Posts: 2
Joined: Tue Nov 08, 2022 5:35 pm

Post Processors - Centroid

Post by scarab4t » Tue Nov 08, 2022 5:45 pm

is there a specific post processor for Centroid Acorn ... would like to know pre purchase

CVH
Premier Member
Posts: 3416
Joined: Wed Sep 27, 2017 4:17 pm

Re: Post Processors - Centroid

Post by CVH » Tue Nov 08, 2022 6:53 pm

Hi,
I don't think you need a special postprocessor.
All depends on the G-code dialect that is supported by the Centroid Acorn.

Of course one can create a custom postprocessor if that would be required.

Regards,
CVH
Last edited by CVH on Tue Nov 22, 2022 4:45 am, edited 1 time in total.

scarab4t
Registered Member
Posts: 2
Joined: Tue Nov 08, 2022 5:35 pm

Re: Post Processors - Centroid

Post by scarab4t » Tue Nov 08, 2022 8:53 pm

@CVH
Hi,
Thanks for response. Any info on post processor creation would be more than welcome
Thanks

CVH
Premier Member
Posts: 3416
Joined: Wed Sep 27, 2017 4:17 pm

Re: Post Processors - Centroid

Post by CVH » Mon Nov 14, 2022 6:09 pm

There is not much to go on ...
https://qcad.org/en/qcad-cam-postprocessor

But you can get help with very specific questions in this forum.

Regards,
CVH

Post Reply

Return to “QCAD/CAM”