Hi,
I have encountered the following problem: when generating the path for my profile (see files), the lowest part of the path is lost. It looks like a very long tab but I did not declare it in that way. Is it my mistake or problem with the CAM module?
Regards,
Konrad
Error in generating gcode?
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Error in generating gcode?
- Attachments
-
- Test2.png (41.51 KiB) Viewed 958 times
-
- Test1.dxf
- (792.67 KiB) Downloaded 56 times
-
- Test1.png (34.08 KiB) Viewed 958 times
Re: Error in generating gcode?
I can confirm.
Can you change the length of the tab at the bottom from 4 to 3.5 and try again?
Can you change the length of the tab at the bottom from 4 to 3.5 and try again?
Re: Error in generating gcode?
I have changed the tab length as you suggested. Unfortunately, it had no effect (see picture) 
Regards,
Konrad
Regards,
Konrad
- Attachments
-
- Test3.jpg (50.86 KiB) Viewed 951 times
Re: Error in generating gcode?
I cannot reproduce that (with tab length 3.5) Could you attach your DXF and G-Code again?
Also, please indicate your QCAD/CAM version and operating system (see forum rules above).
Also, please indicate your QCAD/CAM version and operating system (see forum rules above).
Re: Error in generating gcode?
Fixed. I changed the length from 4 to 3mm and it works 
Any idea what might have been the cause?
I work with the latest release of QCAD/CAM. win10 OS.
Regards,
Konrad
Any idea what might have been the cause?
I work with the latest release of QCAD/CAM. win10 OS.
Regards,
Konrad
- Attachments
-
- Test4.jpg (43.23 KiB) Viewed 949 times