In the profile dialog, if I set the start depth and the cut depth to the same value, the system goes into an endless loop. To stop it, you have to quit QCAD.
I am running on Ubuntu 18.04LTS and I have QCAD/CAM V3.23
I know this is a stupid thing, but it I wish it would just bail, rather than endlessly loop.
Is this where I report problems?
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Re: Is this where I report problems?
For a bug report or a feature request please use https://www.qcad.org/bugtracker
A bug report posted in this forum could be "forgotten" what never happens in that mentioned dedicated forum.
Unfortunately that forum needs a separate registration, your login from this forum will not work.
A bug report posted in this forum could be "forgotten" what never happens in that mentioned dedicated forum.
Unfortunately that forum needs a separate registration, your login from this forum will not work.
Work smart, not hard: QCad Pro
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Re: Is this where I report problems?
I looked at the bug tracker, but I did not see a way to register or login. Do I need to apply or something?
All the best!
Chuck Tilbury
http:/whistlemaker.com
Chuck Tilbury
http:/whistlemaker.com
Re: Is this where I report problems?
Yes.There should be a link (Login) at the upper right corner or just use this ling for the first registration:
https://www.qcad.org/bugtracker/index.php?do=register
Work smart, not hard: QCad Pro
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."