Often, here in the machine shop I am confronted with the wonderful task (who am I kidding... ) on cleaning up drawings for either cnc output or for presentation purposes and after many hours of scrambling about with hatching work I eventually came up with a quick and easy solution to hatch an area without all of the clean up needed - yes sometimes it is easy to prepare a boundary for hatching but at other times it is not and if the final output is for diagrammatic purposes only then the following method should suffice!
The method:
Step 1/ Turn off all other unnecessary layers leaving only the one showing what you need to crate a boundary with.
Step 2/ Set up a new layer 'Trace'.
Step 3/ Drafting on layer 'Trace', select to use the Spline tool ( Control Points).
Step 4/ Select the snap option -'On Entity'.
Step 5/ Using the spline tool trace around the area needed to create a boundary, just follow the profile around snapping as you go - you will need to snap more frequently and closer together to achieve a better fit at corners - this process doesn't take as long as you think!
Step 6/ When you have completed your tracing, turn off the underlying layer to only leave the layer 'Trace'. Then with the spline selected go to the Hatch tools and select 'Hatch from selection'.
Step 7/ In the Hatch dialog window, choose the hatch type you need and hit the OK button.
Step 8/ Delete the spline, to leave only the hatching.
Step 9/ Select the hatching and in the property editor change the hatch to the layer you need!
Step 10/ Turn on the layers again and job done
Hatching workaround - for diagrammatic purposes only!
Moderator: andrew
Hatching workaround - for diagrammatic purposes only!
For the best support please state your operating system, QCAD version and add any supporting DXF/DWG files, screenshots etc...
Re: Hatching workaround - for diagrammatic purposes only!
Clive this is awesome. I vote this as a good avenue to do hatching. I am used to tracing on digitizers and this will be a breeze.
Thank you so much. I feel honored you would use my drawing as a help me doc.
Thank you so much. I feel honored you would use my drawing as a help me doc.
Best Regards,
Eric Pate
CNC Technical Director
Terminator Diamond Products, Inc
https://www.terminatordia.com/
Eric Pate
CNC Technical Director
Terminator Diamond Products, Inc
https://www.terminatordia.com/
Re: Hatching workaround - for diagrammatic purposes only!
Hi Eric,
Glad to help, now you have to get on with the work
All the best,
Clive
Glad to help, now you have to get on with the work
All the best,
Clive
For the best support please state your operating system, QCAD version and add any supporting DXF/DWG files, screenshots etc...