Hi Andrew,
not sure if anyone else has already asked that question, but I have tons of SKF files from Autosketch. I assume there is no way to get them converted to dxf or dwg in an automated way?
So the only way is to open them one by one in Autosketch and save them as dxf?
Anyone else here in the board who might has an idea or maybe already a workaround? I guess there are quite a lot of former Autosketch users around and have the same problem.?
Importing SKF files
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
-
- Senior Member
- Posts: 107
- Joined: Wed Dec 06, 2017 4:06 pm
- Location: Germany - Heidelberg
Importing SKF files
Best Regards
Sven
QCAD 3.27.6.0 / Windows 11 Professional 64-bit / 16 GB RAM, i5 [email protected], SSD
(former Autosketch 10 user)
Sven
QCAD 3.27.6.0 / Windows 11 Professional 64-bit / 16 GB RAM, i5 [email protected], SSD
(former Autosketch 10 user)