When I print the extension lines of the dimensions print on top of the actual drawing lines. I'm choosing to print the dimension lines in light grey so the drawing can be seen clearly, but this then leaves gaps in the drawing where the extension lines are.
Is there a way to push the dimension layer down so it doesn't overwrite the drawing lines?
W10, V 3.21.3.0 (3.21.3)
Dimension extension line printing problem
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
-
- Junior Member
- Posts: 18
- Joined: Sat Dec 30, 2017 12:51 pm
Re: Dimension extension line printing problem
In the Layer List right-click the layer with the dimensions and choose Select Layer
then use Modify /Draw Order / Send to Back
hope it helps.
Massimo
then use Modify /Draw Order / Send to Back
hope it helps.
Massimo
-
- Junior Member
- Posts: 18
- Joined: Sat Dec 30, 2017 12:51 pm
Re: Dimension extension line printing problem
Great, thank you