line trimming (SOLVED)

[Certina]

Hello
Where to find the line trimming tool.
For example, two lines intersect and I want to trim part of the line to the point of intersection.

Regards - Certina

[CVH]

Hi,
See menu Modify:
Trim (RM)
Trim Both (TM)
You could key in 'RM' or 'TM', these are called schorcuts.

Regards,
CVH

[Husky]

@ Certina,

For example, two lines intersect and I want to trim part of the line to the point of intersection.

This can be done with the "Break out Segment" (D2) tool:
https://www.qcad.org/doc/qcad/latest/re ... ro_en.html

Depending on the given situation "Break out Manual" (B2) and "Auto Trim" (AX) would be an option too.

[Certina]

Thank You very much for the hints.
Unfortunately, there is no way I can truncate the line with the proposed method.
I cannot cut two lines with marked dimensions: 18.25 and 29.79
image link:
https://www.dropbox.com/s/0pg5g7khgfaf4 ... e.jpg?dl=0

Regards - Certina

[Husky]

Unfortunately, there is no way I can truncate the line with the proposed method.

Please elaborate why not. I've no problems to modify those lines with "Trim", "Break out Segment" or "Auto Trim" ...

Trim:

Trim.gif (386.54 KiB) Viewed 2163 times

Break out Segment:

Break out Segment.gif (347.06 KiB) Viewed 2163 times

Auto Trim

Auto Trim.gif (285.01 KiB) Viewed 2103 times

[Certina]

Thank You very much for the detailed explanation.
<Break out Segment> that is, <podziel na segmenty> is what I meant.
Thanks
Regards, Certina