I took a look at snapshot 3.25.2.1 on macOS.
The change records speak of "Draw> Spline > Append Fit Point (s)".
When I try to attach a new fit point to a "spline with fit points" using the new tool, the tool stops responding and I cannot attach anything to anything.
What did I misunderstand?
Thomas
Spline > Append Fit Point (s)
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Spline > Append Fit Point (s)
Ich will nicht streiten. Ich will nur deutlich machen, dass ich Recht habe und DU NICHT.
Re: Spline > Append Fit Point (s)
Thanks for your report. The problem has been fixed for the next release.
The tool only works in 3.25.2.1 when launched from the context menu:
- Right-click on a spline with fit points
- choose "Append Fit Point(s)"
The tool only works in 3.25.2.1 when launched from the context menu:
- Right-click on a spline with fit points
- choose "Append Fit Point(s)"
Re: Spline > Append Fit Point (s)
Yes, launching from the context menu works pretty well.
Thank you.
Thomas
Thank you.
Thomas
Ich will nicht streiten. Ich will nur deutlich machen, dass ich Recht habe und DU NICHT.
Re: Spline > Append Fit Point (s)
In 3.25.2.2 under macOS the appending of spline points works.
Instead, no more spline points can be inserted in closed splines when the attribute of the spline says Closed: No. Not even via the context menu.
Thomas
Instead, no more spline points can be inserted in closed splines when the attribute of the spline says Closed: No. Not even via the context menu.
Thomas
Last edited by TSG on Fri Oct 30, 2020 11:30 am, edited 1 time in total.
Ich will nicht streiten. Ich will nur deutlich machen, dass ich Recht habe und DU NICHT.
Re: Spline > Append Fit Point (s)
I cannot reproduce that here.
Please make sure the closed spline does have fit points (not control points).
If you can't solve it:
- is the context menu entry "Insert Fit Point" shown for the spline?
- what happens if you try to insert a fit point using the context menu?
- please attach the file
Thanks.
Re: Spline > Append Fit Point (s)
As I found out, it's a little bit more complicated and hard to describe.
It depends on the attrribute "closed periodically".
Here an example.
Thomas
It depends on the attrribute "closed periodically".
Here an example.
Thomas
- Attachments
-
- Insertion of spline points.dxf
- (105.66 KiB) Downloaded 319 times
Ich will nicht streiten. Ich will nur deutlich machen, dass ich Recht habe und DU NICHT.