Hello,
I would like to know if we can make an auto-orientation from a dwg file to pdf file.
With command line, I used --auto-orientation, but the orientation was the same. The drawing is inclined and I would like it to be straight.
If anyone has the answer I would be thankful
Debian 10
QCAD version 3.22.1
DWG file below
Auto-orientation
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Auto-orientation
- Attachments
-
- menuire.dwg
- (149.58 KiB) Downloaded 274 times
Re: Auto-orientation
"Auto orientation" refers to the paper orientation (landscape for drawings that are wider than tall, portrait otherwise). The drawing is not rotated or changed in any way by this option.
Re: Auto-orientation
Ok thanks for your answer, so there is no option to do this ?
Re: Auto-orientation
No, there's no option to rotate or otherwise change the drawing in dwg2pdf.
If it's an option to do it manually, you could create a layout block with a viewport that displays the rotated drawing (angle 119.534361, scale 0.005): This way you don't have to change the drawing and you can still display / print / export it straight.
If it's an option to do it manually, you could create a layout block with a viewport that displays the rotated drawing (angle 119.534361, scale 0.005): This way you don't have to change the drawing and you can still display / print / export it straight.