QCAD.org Forum

How should I best go about hatching a drawing like the attached? I've tried Hatch From Selection but the selection process seems to drop out long before I've got all around the stairs.
Louise

Win 10 QCAD Version: 3.19.2.0 (3.19.2) Internet: QCAD.org Build Date: Dec 20 2017 Revision: 1f70332Qt Version: 5.5.1 Architecture: x86_64 Compiler:MSVC++ 12.0 (2013)

Hi Louise,

Nice drafting work.

Try the 'Hatch from segments' tool instead!

Regards

Clive

Clive wrote:Hi Louise,

Nice drafting work.

Try the 'Hatch from segments' tool instead!

Regards

Clive

But how does the tool work?

Louise

Essentially you would use this tool to select entities to form a boundary to hatch within, the boundary needs to be closed without any gaps at all.