Can one go from QCAD to a CAM program (any suggestion for Mac?) and finaly to the computer on a cnc router?
Your advice please.
From cad to cam to machine
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Re: From cad to cam to machine
Yes, that is how CAM typically works. The whole process depends a lot on your specific needs, but a typical use case would be:
- Create CAD drawing using CAD (output: DXF file).
- Generate program for computer controlled machine from CAD drawing (output: typically G-Code or similar).
- Load program into machine and process work piece.
- Create CAD drawing using CAD (output: DXF file).
- Generate program for computer controlled machine from CAD drawing (output: typically G-Code or similar).
- Load program into machine and process work piece.
Re: From cad to cam to machine
Thank you Andrew, I started an other question here:
viewtopic.php?f=32&t=3991&p=14522#p14522
Can you see there what the question is and what the reply?
Regards,
Luc
viewtopic.php?f=32&t=3991&p=14522#p14522
Can you see there what the question is and what the reply?
Regards,
Luc