Snap Lock SQ not working
Posted: Fri Jun 28, 2019 6:57 pm
Greetings,
I can't seem to get Snap Lock to work, maybe I'm doing something wrong?
I select a snap say for instance end. Good all endpoints are snapped. Then I enable Snap Lock (command line SQ or by clicking the button) and choose say Middle. Now only mid points are will snap! What happened to endpoints? Seems like the snap lock isn't working. I would expect once snap lock is engaged all selected snaps would appear selected in the toolbox until they are toggled off or snap lock is disabled.
Where do you suppose I have gone wrong?
Version: 3.22.1.0 (3.22.1)
Internet: QCAD.org
Build Date: May 21 2019
Revision: 46d6499
Qt Version: 5.5.1
Architecture: x86_64
Compiler: MSVC++ 12.0 (2013)
I can't seem to get Snap Lock to work, maybe I'm doing something wrong?
I select a snap say for instance end. Good all endpoints are snapped. Then I enable Snap Lock (command line SQ or by clicking the button) and choose say Middle. Now only mid points are will snap! What happened to endpoints? Seems like the snap lock isn't working. I would expect once snap lock is engaged all selected snaps would appear selected in the toolbox until they are toggled off or snap lock is disabled.
Where do you suppose I have gone wrong?
Version: 3.22.1.0 (3.22.1)
Internet: QCAD.org
Build Date: May 21 2019
Revision: 46d6499
Qt Version: 5.5.1
Architecture: x86_64
Compiler: MSVC++ 12.0 (2013)