Search found 6 matches
- Thu Dec 24, 2020 2:48 pm
- Forum: QCAD 'How Do I' Questions
- Topic: [Solved] Set line to specific length at a specific angle
- Replies: 4
- Views: 4040
Re: Set line to specific length at a specific angle
At least this seems to be doable using the propety editor, where the length can be set, but are there any other ways to do this?
- Thu Dec 24, 2020 2:39 pm
- Forum: QCAD 'How Do I' Questions
- Topic: [Solved] Set line to specific length at a specific angle
- Replies: 4
- Views: 4040
[Solved] Set line to specific length at a specific angle
I'm making a drawing of a wooden toy garage and here is the side view of it. The roof of the garage should be 287 mm long and on the left side in the picture, it is coming 4 mm out from the wall. So the left side is correct. On the right side the amount of millimeters is not that exact how much it s...
- Thu Sep 17, 2020 11:48 am
- Forum: QCAD 'How Do I' Questions
- Topic: How do I extend line and keep the same angle?
- Replies: 9
- Views: 7370
Re: How do I extend line and keep the same angle?
Thank you, this was good information.
I just also found out, that the "Relative Angle" tool could also be used.
I just also found out, that the "Relative Angle" tool could also be used.
- Thu Sep 17, 2020 11:38 am
- Forum: QCAD 'How Do I' Questions
- Topic: How do I extend line and keep the same angle?
- Replies: 9
- Views: 7370
How do I extend line and keep the same angle?
I'm using QCAD Pro 3.25.0 and attempting to make a drawing of a house. Please have a look at the attached image. What is the best way to extend the line in the same direction as the red arrow is pointing at? This is the eaves of the roof and I would need to make it exactly 625 mm long and it should ...
- Thu Aug 13, 2020 10:31 am
- Forum: QCAD Suggestions and Feedback
- Topic: "dist" command in addition to "infodist"
- Replies: 4
- Views: 6395
Re: "dist" command in addition to "infodist"
Thank you, the command ip is fine. Faster to use.
- Mon Aug 10, 2020 1:04 pm
- Forum: QCAD Suggestions and Feedback
- Topic: "dist" command in addition to "infodist"
- Replies: 4
- Views: 6395
"dist" command in addition to "infodist"
Would it be possible to get a "dist" command that would do the same as "infodist" command?
It would be faster to use, if there would be an additional command to the "infodist" command.
Or is there any way to rename commands in the current Pro version of QCAD?
It would be faster to use, if there would be an additional command to the "infodist" command.
Or is there any way to rename commands in the current Pro version of QCAD?