Search found 7 matches
- Tue May 21, 2019 1:02 pm
- Forum: QCAD Community Edition
- Topic: Fonts and positions different when reopening
- Replies: 9
- Views: 11963
Re: Fonts and positions different when reopening
i just tried to reset QCAD but it didnt bring back the trial. after resetting and opening the same drawing it still gives the same issue.
- Mon May 20, 2019 9:22 pm
- Forum: QCAD Community Edition
- Topic: Fonts and positions different when reopening
- Replies: 9
- Views: 11963
Re: Fonts and positions different when reopening
i have noticed that i dont have the ability to change the font of the drawing under "Edit->Drawing Preferences->Dimension Settings" i dont have a "Dimension Label Font" section
- Mon May 20, 2019 9:17 pm
- Forum: QCAD Community Edition
- Topic: Fonts and positions different when reopening
- Replies: 9
- Views: 11963
Re: Fonts and positions different when reopening
here are 2 screenshots. i added comments to each picture
- Mon May 20, 2019 8:34 pm
- Forum: QCAD Community Edition
- Topic: Fonts and positions different when reopening
- Replies: 9
- Views: 11963
Re: Fonts and positions different when reopening
thank for checking it out.
Well when i opened it everything was in Tahoma as you stated. at the top right of the drawing where it says "original drawing" is it off centered? i was reading in another post and someone said i might not be able to change the fonts because i was on the community version
Well when i opened it everything was in Tahoma as you stated. at the top right of the drawing where it says "original drawing" is it off centered? i was reading in another post and someone said i might not be able to change the fonts because i was on the community version
- Mon May 20, 2019 7:04 pm
- Forum: QCAD Community Edition
- Topic: Fonts and positions different when reopening
- Replies: 9
- Views: 11963
Re: Fonts and positions different when reopening
Sorry for the late reply wasnt receiving emails.... haha yea thats usually my luck. i have attached a file see how this opens for you.
- Thu May 16, 2019 9:21 pm
- Forum: QCAD Community Edition
- Topic: Fonts and positions different when reopening
- Replies: 9
- Views: 11963
Fonts and positions different when reopening
when i make a print and save it, when i go to reopen it all of the texts are different (i save them as Tahoma, when i open the print again its back to Standard). Then if i change the text height in the Dimension preferences all the fonts change back to Tahoma. also then i have a text alignment set t...
- Thu Dec 06, 2018 2:51 pm
- Forum: QCAD Troubleshooting and Problems
- Topic: grid spacing
- Replies: 12
- Views: 13710
Re: grid spacing
Hi Caster, The answer is in 'Edit->Drawing Preferences->Dimension Settings'. You will see that the 'Dimension Label Font' box is empty. Select a font and click 'Apply', and the labels will change to metric. Hope this helps Regards riverbuoy Hi, I am currently using version 3.21.2.0 on windows 7. Wh...