- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Medium
- Priority Very Low
- Reported Version 3 RC3
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Malcolm White - 14.12.2011
Last edited by Andrew - 14.12.2011
Opened by Malcolm White - 14.12.2011
Last edited by Andrew - 14.12.2011
FS#435 - QCAD3 RC3 Windows XP - Stretch command does not appear to function
The modify tools → stretch command does not appear to function.
The two attachments contain the source drawing (blackburne_engine_breather_0210A.dxf) and five screen shots (qcad3_rc3_stretch.odt) showing the steps taken to replicate the problem.
I have also performed a similar exercise with a Linux trial version 3.0 RC2 (OpenSuse 11.4) with the same result.
Regards
Closed by Andrew
14.12.2011 19:41
Reason for closing: Not a bug
Additional comments about closing:
14.12.2011 19:41
Reason for closing: Not a bug
Additional comments about closing:
Improvement: r20017
Can you please try to 'draw' the stretch area well over the edge of the part you want to stretch as shown in the user manual at:
http://www.ribbonsoft.com/qcad/manual_reference/chapter28.html#10
Stretching means moving all end points inside the given rectangular area. If the area is drawn with a zero height or width, nothing will be stretched.
Next release will allow for zero-width / zero-height box and support the way you tried to stretch.
Thank you for the clarification. I was following what I did in v2.2.2.0. Not realising that I was missing a trick.
I have now been able to stretch the entity. Thank you for including this anomaly in the next release. Regards.