- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.26.4
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Tomas Novak - 23.07.2021
Last edited by Andrew - 24.08.2021
Opened by Tomas Novak - 23.07.2021
Last edited by Andrew - 24.08.2021
FS#2262 - Block referece attributes are orpaned when using "edit in place"
This happens only when using “save and update” and then “close”. “save and close” works ok. See in video
Buttons for adding and removing from working set seams buggy for me when I played with them for a while (some block references completely disappear form drawing). But I am not able to describe this behavior.