- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Windows 10
- Severity Low
- Priority Very Low
- Reported Version 3.26.2
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Tomaž Zupan - 27.04.2021
Last edited by Andrew - 24.06.2021
Opened by Tomaž Zupan - 27.04.2021
Last edited by Andrew - 24.06.2021
FS#2235 - Invalid symbol table name
Hello,
I have got a dwg file from architect, which I can open, but I get “Invalid symbol table name” when I try to save it. I do not know which software was used to create it.
I have tried to change all spaces and national characteds in block and layers names as advised elswhere, but that didn’t help.
Lp
Tomaž
Closed by Andrew
24.06.2021 16:19
Reason for closing: Fixed
Additional comments about closing:
24.06.2021 16:19
Reason for closing: Fixed
Additional comments about closing:
This has likely been fixed in QCAD
3.26.4, please re-open otherwise.
The cuprits seem to be two blocks with the names
Hina delavnica_05_4
and
Hodnik_ stopniče_01_6
Note that "š" type character "" which is invisible in QCAD and might be shown as a square in your browser or as a faint "š". You can either remove that or replace it by a normal "š" or "s".
Indeed, after renaming those two I can save my changes!
I missed them because they were "invisible" in block editor.