FS#2160 - Draw > Polyline > Relocate Start Point: fails on polylines with bulges
QCAD Professional
Win installer 32bit
Version: 3.25.2.7 (3.25.2.7)
Internet: QCAD.org
Build Date: Dec 16 2020
Revision: e06f230
Qt Version: 5.13.2
Architecture: i386
Compiler: Unknown
Origin:
I like to start my CAM paths at low curvature instead starting at high curvature.
Ellipses may explode with the startpoint at the tip. (file Y2)
Documented in 3.25.2.4, reproducible under 3.25.2.7
File included with 4 LayerStates
- Original Ellipses: Y1
- Exploded to polylines (32 segments): Y2
- Direct after XP, OR performs different on the left top one: Y3
- Faulty solutions by OR: Y4 (= saved state)
The results may differ with the saved explosions.
With the file.
Y1
TA
XP
Relocate startpoint with OR to an existing reference (called ‘End’)
Regards,
CVH
Again: 2x wrongtoken, not able to go back.
Had the text preserved in Notepad.