- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.24.3
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Larry Buller - 05.07.2020
Last edited by Andrew - 13.07.2020
Opened by Larry Buller - 05.07.2020
Last edited by Andrew - 13.07.2020
FS#2096 - trim fail between line and arc
Trim, or round do not work between the green line and the magenta arc. The line properties do not report the length correctly.
Info - distance reports the distance between the end point of the magenta arc and the start point of the red arc as .1534. the Property editor reports the green line length as .257.
If the length of the green line is edited to .5 inches then trim and round work properly, and the green line length is reported properly. The other line/arc intersections have been edited in this manner.
The line has Z values (i.e. is 3D).
Flatten with Misc > Modify > Flatten Drawing to 2D.