- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD/CAM
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.23.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 20.11.2019
Last edited by Andrew - 20.11.2019
Opened by Husky - 20.11.2019
Last edited by Andrew - 20.11.2019
FS#2001 - CAM > Nesting: Alignment fails
Description for the CAM Nesting alignment:
Quote:
Alignment: Parts are arranged with the chosen alignment in mind. An alignment of “Left - Bottom” means that parts are shuffled to the left (primary alignment) and towards the bottom (secondary alignment).
Quote end
I tested a few scenarios. e.g
a Top Left, Align → leads to a top right alignment,
a Top left, Hull → leads to a Bottom Left alignment,
etc.