- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Windows 10
- Severity Low
- Priority Very Low
- Reported Version 3.22.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Larry Buller - 29.03.2019
Last edited by Andrew - 30.03.2019
Opened by Larry Buller - 29.03.2019
Last edited by Andrew - 30.03.2019
FS#1866 - DXF: EXTMIN/EXTMAX interchanged
In the attached drawing, the origin is at the lower left, but $EXTMAX 10 = 0, 20 = .66473 and $EXTMIN = 10 = 3.2, 20 = 0
The X value for $EXTMAX should be 3.2
The X value for #EXTMIN should be 0
the following is an excerpt from the file
$EXTMIN
10
3.2
20
0.664730029289
30
0.0
9
$EXTMAX
10
0.0
20
0.0
30
0.0
the original file was drawn with EasyCAD and when saved reports properly, when opened and saved in QCAD reports as listed