- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.21.3
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Adam Zalonis - 13.01.2019
Last edited by Andrew - 13.01.2019
Opened by Adam Zalonis - 13.01.2019
Last edited by Andrew - 13.01.2019
FS#1845 - Block reference points cannot be supressed in printer output/print-preview
Drawing preferences have no effect on point type when printed or in print-preview for block reference points.
Notice in “print output”, the “Dot” (Block reference point) is displayed (drawing preferences are ignored).
See attached photos.
Closed by Andrew
13.01.2019 21:04
Reason for closing: Not a bug
Additional comments about closing:
13.01.2019 21:04
Reason for closing: Not a bug
Additional comments about closing:
Intended behavior
This is intended behavior. The block display preferences only affect the display, not the print. Accordingly, the point sizes are in pixels (for the screen).