- Status Closed
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.17.1
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Opened by shoorick - 30.05.2017
Last edited by Andrew - 30.05.2017
FS#1588 - "hole" realisation
Trying to design PCB with QCad (as hobby ;) I found an inconvenience with routing tracks through holes: I need end one line, snapped to the one edge of contact pad and start new line from other side of the pad, otherwise if line goes through the hole and covers it, hole disappears or becomes damaged; or I need to clean each hole of track parts before printing.
so, subject is: to define a certain area of white or background colour, so if any object (line or other shape) intersects it, it will be just invisible inside this area. they may still be visible, say, in draft mode.
I’ve been thinkig about simpliest way to make it, but not sure. Maybe it can be an additional property of the hatch, or it can be specific “background” solid colour, which can be applied to the hatch (apply this colour to other kind of object is not a good idea).
Then contact pad can be defined as shape with smaller round hatch inside to designate hole, so we can route lines, snapping them to the hole centers, not caring about clearing these holes later of little pieces of tracks.
Maybe it can be usefull :) Thanks for your great work!