FS#2160 : Draw > Polyline > Relocate Start Point: fails on polylines with bulges

Quick Actions

View Dependency Graph

Status Assigned
Percent Complete
0%
Task Type Bug Report
Category QCAD (main)
Assigned To

andrew
Operating System All
Severity Low
Priority Very Low
Reported Version 3.25.2
Due in Version Undecided
Due Date Undecided
Votes
1
- CVH (24.12.2020)
Private

Attached to Project: QCAD Bugtracker
Opened by CVH - 24.12.2020
Last edited by andrew - 24.12.2020

FS#2160 - Draw > Polyline > Relocate Start Point: fails on polylines with bulges

QCAD Professional
Win installer 32bit
Version: 3.25.2.7 (3.25.2.7)
Internet: QCAD.org
Build Date: Dec 16 2020
Revision: e06f230
Qt Version: 5.13.2
Architecture: i386
Compiler: Unknown

Origin:
I like to start my CAM paths at low curvature instead starting at high curvature.
Ellipses may explode with the startpoint at the tip. (file Y2)

Documented in 3.25.2.4, reproducible under 3.25.2.7

File included with 4 LayerStates
- Original Ellipses: Y1
- Exploded to polylines (32 segments): Y2
- Direct after XP, OR performs different on the left top one: Y3
- Faulty solutions by OR: Y4 (= saved state)

The results may differ with the saved explosions.

With the file.
Y1
TA
XP
Relocate startpoint with OR to an existing reference (called ‘End’)

Regards,
CVH