I recently upgraded from 3.5.1 (Linux/64) to 3.9.5, to 3.9.6, to 3.9.7. A client needed some revisions to some drawings, and to my shock, I found that I couldn't create proper PDF files, because the entire drawing would be down and to the left enough to cut the bottom and let off. Attempting to compensate by shifting the page around resulted in the top being cut off.
I kept 3.5.1 on my computer, and was eventually able to create good PDF's using it, but I thought that 3.9.7 was supposed to solve this problem. The PDF generation is basically unusable.
I'm sure glad I kept 3.5.1.
[solved] PDF output off center
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Re: PDF output off center
Please attach said drawing for testing or send it via e-mail, thanks.
I'm not aware of any such a problem with any version of QCAD.
I'm not aware of any such a problem with any version of QCAD.
Re: PDF output off center
Here's an example of the PDF output with 3.9.7. You can see how the bottom is cut off.
- Attachments
-
- WE2397.pdf
- (766.07 KiB) Downloaded 497 times
Re: PDF output off center
It is possible to print only a part of a drawing with QCAD. This is intended behaviour. It should of course also be possible to print the complete drawing, most likely you can do this by following these three simple steps:
- File > Print Preview
- Click the button to center the drawing on paper: - File > PDF Export or Print
If you could attach or send the drawing file (DXF or DWG), I can check if there are any other problems with this file.
- File > Print Preview
- Click the button to center the drawing on paper: - File > PDF Export or Print
If you could attach or send the drawing file (DXF or DWG), I can check if there are any other problems with this file.
Re: PDF output off center
Guido: I've split your question into a separate thread since it is very likely unrelated to this thread:
viewtopic.php?f=33&t=3609
viewtopic.php?f=33&t=3609
Re: PDF output off center
This issue should be fixed in the current 3.9.8 release.
Re: PDF output off center
3.9.8 fixed the problem.