QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.0.0
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by galio - 13.06.2013
Last edited by Andrew - 14.06.2013

FS#825 - Move non single straight line away from Line Tools

Line Tools menu would be way clearer as it would only create single straight lines.

This can be achieved by implementing FS#822 and  FS#824 .

Closed by  Andrew
14.06.2013 20:47
Reason for closing:  Won't implement
Andrew commented on 14.06.2013 20:46

The rectangle and polygon tools should be considered auxiliary line tools which produce commonly used shapes with lines. These shapes usually serve as a basis for a more complex drawing. In the process of creating this more complex drawing, the original shape will likely not survive as a whole at which point single lines are more appropriate than a polyline.


Available keyboard shortcuts


Task Details

Task Editing