- Status Assigned
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Defer
- Reported Version 3.0.0
- Due in Version Undecided
-
Due Date
Undecided
-
Votes
1
- CVH (24.10.2022)
- Private
Attached to Project: QCAD Bugtracker
Opened by Joachim Roettinger - 25.11.2012
Last edited by Andrew - 25.11.2012
Opened by Joachim Roettinger - 25.11.2012
Last edited by Andrew - 25.11.2012
FS#724 - Useless reference point entering when moving relatively
Hi,
this is a usability feature request:
If you want to move an object relatively to any point (e.g. by entering @x;y in commandline) it does’nt make sense to enter a starting reference point. Of course this is possible by clicking to any location on the screen. But it’s difficult to change between mouse and keyboard so often.
It should be possible to enter a “don’t care” or “any” reference point by pressing a keyboard shortcut (e.g. enter like in AutoCAD).
Thx