- Status Closed
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.0.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 19.09.2012
Last edited by Andrew - 24.09.2012
Opened by Anonymous Submitter - 19.09.2012
Last edited by Andrew - 24.09.2012
FS#683 - Convert Spline to Polyline tool
To have a tool that could convert splines to polylines would be useful, particularly for laser cutting work where a nice steady flow is needed, otherwise you can get an erratic ‘jumpy’ movement when cutting..
Maybe a ‘two’ step procedure;
1.First convert to arc/line segments.
2. Then if needed convert to a continuous polyline.
1. Select spline
2. Modify - Explode
- The spline is converted ('exploded') into a polyline with line segments.
If loose line entities are desired, explode the polyline again.
Yes of course it works, must be day dreaming here.
thanks Andrew