- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.20.1
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
FS#1761 - Info Polyline area does not find polylines (II)
Selecting Info // Polyline area
And hovering over a drawing with all kinds of entities.
Does not find any polyline on the drawing hovering over them.
Nor clicking on them.
Not a locked layer issue.
All are visible.
I cannot reproduce. Please attach drawing file if possible.
Note that this tool outputs the polyline area into the command line history by default (output can also be added to drawing as text). If the command line is off, there might not be any visible output when clicking a polyline.
Close it or change it to feature request.
Assumed similar behaviour as IR & IC. (are in same section)
Tried to use it as a faster way to detect minute differences in similar areas by just hovering over them. Will place some 200 values on my drawing then.
BTW: Related: Did you read solution to
FS#1756on https://www.qcad.org/rsforum/viewtopic.php?f=31&t=5590