- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.16.4
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 19.01.2017
Last edited by Andrew - 19.01.2017
Opened by Anonymous Submitter - 19.01.2017
Last edited by Andrew - 19.01.2017
FS#1532 - Selection Problem ?
Please attached file. When dragging a selection window across only the cyan lines -I get only one line selected?
The line at the left is 3D (i.e. at least one Z coordinate is not 0). This is currently not supported by the area selection tool.
Thanks Andrew, now I'm confused as these are lines I drew ???
You were likely snapping to one of the red lines which are also at Z = -52.5.
You might want to use Misc > Modify > Flatten Drawing to 2D to make sure all Z levels are set to 0 (unless you wish to preserve those levels of course).
No I don't need them, excellent thanks Andrew, didn't even know we had that tool!