- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Windows 10
- Severity Low
- Priority Very Low
- Reported Version 3.15.5
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 20.10.2016
Last edited by Andrew - 20.10.2016
Opened by Anonymous Submitter - 20.10.2016
Last edited by Andrew - 20.10.2016
FS#1494 - polyline offset fails ?
Hi Andrew
Exploded a spline, then created a single polyline from the segments ... but I cannot offset it, to produce another one ?
Is this a bug ?
Regards
Clive
I'm unable to reproduce. What are your parameters (distance, etc.)?
To offset by 6mm
Ha, got it, sorry not using 'whole polyline'.
by the way I've sent you a private message.
OK, I'll close this report.