- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Windows (All)
- Severity Low
- Priority Very Low
- Reported Version 3.10.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 28.09.2015
Last edited by Andrew - 28.09.2015
Opened by Husky - 28.09.2015
Last edited by Andrew - 28.09.2015
FS#1272 - Modify > Auto Trim: not undoable when used on spline
Scenario 1:
like to use “Breakout segment” on a spline,
Status bar tells me that I CAN use this tool on a spline,
Breakout: works,
Undo: works,
Everything fine ...
Scenario 2:
like to use “Breakout manual” on a spline,
Status bar tells me NOT to use this tool on a spline but ...
Breakout manual: works,
Undo: works,
I think just the status bar needs an Infotext update.
Scenario 3:
like to use “Auto Trim” on a spline,
Status bar tells me NOT to use this tool on a spline but ...
Auto Trim: works,
Undo: works NOT,
I think the status bar needs an Infotext update and I guess in the undo function is a bug.
Closed by Andrew
28.09.2015 09:57
Reason for closing: Fixed
Additional comments about closing:
28.09.2015 09:57
Reason for closing: Fixed
Additional comments about closing:
https://github.com/qcad/qcad/commit /135c290bc03a7032dfa59af9af388b31e44662f f