- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.7.5
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 12.01.2015
Last edited by Andrew - 12.01.2015
Opened by Anonymous Submitter - 12.01.2015
Last edited by Andrew - 12.01.2015
FS#1162 - Show Large Cross Hairs - not working
Setting to show Large Cross Hairs fails, even after a restart.
I cannot reproduce this here. Perhaps, you are expecting something else from this preference? The setting should give you a large crosshair for the mouse cursor when in snapping mode (e.g. when drawing a line, etc).
If you cannot solve it, could you post a screenshot while drawing lines? Thanks.
Ah, that's weird it's working again now.
OK, thanks. Perhaps, you accidentally ticked the wrong cross hair preference (for the absolute zero point).