- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.4.5
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by William Swanson - 31.12.2013
Last edited by Andrew - 28.04.2018
Opened by William Swanson - 31.12.2013
Last edited by Andrew - 28.04.2018
FS#1002 - Move/Rotate does not remember last-used angle
Steps to reproduce:
- Select an entity
- Activate the move/rotate tool (MR)
- Enter some angle into the dialog box
- Hit OK
- Repeat steps 1-2
- Notice that the angle that was entered in step 3 is not remembered, but that the dialog box always contains the same default angle.
Expected results:
The angle entered in step 3 should be remembered between invocations of the tool, just as it is for the plain rotate tool.
I forgot to mention, this has been broken since at least 3.1.2, and maybe earlier - well over a year now.
XP32/3.4.5.
Hi,
it works just fine for me. No default angle and the given angle is remembered correctly ...
Ah, I see what the difference is. The version set in the toolbar is remembered, but the version set in the dialog box is not.
I assume this can be closed now.